Call now to get tree helping including tree cut, tree drop, bush pruning, shrub felling, stump trimmers and many other in United States


Call us now

Call us now +1 (855) 280-15-30










Replies 5 Views

Buick ElectraSupreme Front Lower Control Arm Bushing by Mevotech. Quantity: 1 per Pack.

Hi, I may have to make some suspension parts also, so I am curious about the material you will use for the shafts.

Control arm bushings provide a pivot point from the control arm and maintain the lateral and vertical location of the control arm pivot Built to match or go beyond OE standards Direct replacement.Buick RivieraSupreme Front Lower Control Arm Bushing by Mevotech. Quantity: 1 per Pack.

Control arm bushings provide a pivot point from the control arm and maintain the lateral and vertical location of the control arm pivot Built to match or go beyond OE standards Direct replacement.Dec 27, The front of the control arm is free to slide up and down. How hard is this busing to replace. Haynes says a machine shop must do the work with special tools to R & R the bushing from the control arm. The Buick Factory Service Manual does cover the procedure, and a multi-piece special tool screw-type bushing puller is used to R & R the bushing.

Location: Front, Driver And Passenger Side, Lower, Inner, Frontward Recommended Use: OE Replacement Warranty: 1-year Replacement unlimited-mileage warranty Bushing Color: Natural Replaces OE Number:Material: Metal and Rubber Returns Policy: Day Return Policy Quantity Sold: Set of 2 Components: (2) Control Arm Bushings.

Dec 17, for rears rjc sells a tool for the bushings in the axle ears, only safe way to go to change out the rear arm bushings i use a 2lb sledge, the bushing driver from the RJC kit, a peice of muffler pipe,a 1 1/8" peice of 1/8 steel strap bent into a J (slide around bushing to prevent arms from collapsing while you drive bushings out and back in) and some wd Nov 02, 5.

Mark the orientation of the control arm bushing in the lower control arm.

Is it a series 40 or 60 or a series 80 or

6. Use the J and the JE in order to remove the control arm bushing. Installation Procedure 1. Align the flat edge of the bushing with the mark on the control arm in order to install the bushing at a 45 degree angle. 2.