Nov 08, To remove, put the rod through both bushings. Pick a bushing to start on. Either one. Find a socket with a diameter that can just pass through the bushing hole from the outside and slide it onto the rod followed by a couple of thick washers and a. T bushings. The above picture is of a bushing kit for a Borg Warner T transmission.
After removing the old bushings properly, by pressing them out, we can press the new bushings into the respective bores they fit in. Not that it is a tough job, but it is easy to ruin a bunch of bushings while you practice installing them in the beginning.
Mar 01, Transmission bushing removal help. I can't find anything online to show me how this is done. Almost very single piece inside the transmission rides on an input or output shaft. They all have bushings, some are teflon coated. I have a full set, but Jake said I'll probably only need a few in some key areas that are prone to wearing out. On and larger bushings use a block, sleeve or drift and hammer large end of bushing (do not hammer bushing directly).
6. Repeat steps 4 and 5 until torque wrench reading, after hammering, is the same as before hammering. 7. Fill all unoccupied holes with grease. This 39 piece Bushing Driver Set covers all Domestic & Import Automatic Transmission Bushings.Read more; R Input Drum Shaft BushingAdd to cart; SPB Sonnax TH 4L80E 4L85E Heavy Duty Case Bushing KitAdd to cart; 40TE, 40TES, 41AE, 41TE, 41TES, 42LE, 42RE, 42RH, 42RLE, 62TE, A, A Pump Bushing Sonnax.